Author Topic: Little Spanky repair (Read 268 times)

bigMouse · « **on:** January 29, 2015, 06:03:10 PM »

Ripped two anti-vib mounts off the Spanky, it cartwheeled when I landed it a bit awkward! No other damage!

bigMouse · « **Reply #1 on:** January 29, 2015, 06:04:42 PM »

I have a load of anti-vib mounts here!

bigMouse · « **Reply #2 on:** January 29, 2015, 06:07:16 PM »

But mine are 8 X 8mm and the Spanky ones are 10 X 10mm, my smaller mountings are probably an ok replacement, at least worth trying!

bigMouse · « **Reply #3 on:** January 29, 2015, 06:09:33 PM »

Biggest issue with the shorter length of 8mm means there is less space between the plates where the ESC's are housed! So printed up some 2mm spacers to increase the length back to 10mm. Seen here in Green...

MK1G4V · « **Reply #4 on:** January 29, 2015, 06:28:19 PM »

This thread reads funny! LOL

"I broke some mounts"....
"I have some mounts"...
"But mine are small"......
"The problem with smaller is...",,,

Don't let the schizophrenia hold you down BM!

Sorry I had too

MrBen · « **Reply #5 on:** January 29, 2015, 07:03:12 PM »

The problem with the original spanky rubbers is they dont glue well at all, the orange QAV ones are great with CA and probably better than the original bond once repaired with CA glue, Im running QAV rubbers on one of my spankys and original ones on the other.

Martink1974 · « **Reply #6 on:** January 29, 2015, 07:08:24 PM »

orange ones are better slightly you can run slightly higher pids without vibes through cam I found when I changed over the spanky ones are moulded 2 part silicone , there is a mould on thingy verse to make them bm