Author Topic: dip switch settings? (Read 597 times)

Balders · « **on:** April 24, 2012, 12:39:06 PM »

Hi folks,

got a question about DIP switch settings. I followed the instructions on my new 2.4 Rx/Tx to set the channels, but I haven't got a stable picture yet. I did get something fuzzy but so that I could see my OSD (barely) but it's presumably down to dip switch combinations. Question is, on the attached diagram, does black indicate the position of the actual switch tab, or white?

Cupid Stunt · « **Reply #1 on:** April 24, 2012, 12:55:24 PM »

Upside down

Well OK not entirely certain but I think they printed the switch pics upside down so try reversing each switch

Dusty · « **Reply #2 on:** April 24, 2012, 01:47:38 PM »

oh mate, i had the same issue.

just a warning... for a given channel, the dip switch "pattern" is not the same on the VTX and the VRX

I just left the VTX on the channel it came on, and kept changing the VRX channel till I got a picture. took a while though

Balders · « **Reply #3 on:** April 24, 2012, 02:02:38 PM »

yeah I know that, annoyingly, the dip switch pattern is different between the manual and the sticker on the blooming Rx as well!

Will just have to go through patterns tonight until it works I guess

Spent about 30 mins on it last night and gave up.

MrBen · « **Reply #4 on:** April 24, 2012, 03:01:42 PM »

black indicates where the switch should be! so for channel 8 on the tx you have the first 3 down on the numbers side and the last one up away from the numbers!

the attached diagram shows the rx channels, my RX has a sticker on the back to show the dip settings