naze ppm mapping

[Brodjackella]

managed to remove the solder pad on pin1...anyone know a way to configure the naze to accept ppm signal on pin2,3,4 etc
I was shortening rx-naze lead...

I would just buy another naze but none in stock uk..

[xxpitt]

Can't be done broderie.  Only thing you can do is use all the servo wires and remap channels. Cppm can only be on channel one though

[xxpitt]

Hobbyking had some in stock a few days ago. They were down to under 10 though so may have all gone now

[xxpitt]

http://www.hobbyking.co.uk/hobbyking/store/uh_viewItem.asp?idProduct=72563 quick broderie uk warehouse too

[bigMouse]

I've got one you can have for £20 posted

[Brodjackella]

suspected that Dave...I solder on to pads,no more of that just too delicate pads to keep unsoldering/resoldering...
bummer as as good as finished my homebew 300 frame too,wanted maiden tomoz...
i'll send pm bm.cheers buddy

[xxpitt]

I've done it twice brod. Once I manage to scrape paint off the tracer going to that pad and solder to it. The other I had to just bin it

[Martink1974]

Sure you could solder ppm to another place , even if you solder to the pin on the chip

[Brodjackella]

possibly but track proper thin,even though my micro soldering good,its my eyes that aint

i'll have a go though rather than bin it

[Brodjackella]

naze arrived earlier...cheers BM

[rdr]

pads 1 2 3 come from what looks like a resistor pack that's marked 102. you could isolate pad 2 from it's pin on the resistor pack and rewire it to the pin for pad 1, then use pad 2 as pad 1.

[xxpitt]

Sounds a delicate operation