FMX250 LED Mini Quadcopter ARF RTF

[fpvmodel]

These are the newest ARF packages of FMX250 with PCB board and LED lights.

If you wish a pleasant flying experience with a compact beautiful mini quad and also flying in the night, then don't miss out FMX250 mini quad packages. Everything you need to build the quad are almost included. We tested every part to make sure all of them are matched and performed well. Worry free and just enjoy your FPV now.

Three ARF packages with different flight controllers are available for your selection. They are the same accessories but just with flight controllers.

An RTF package is also offered, the same parts as the ARF3 package, but we've assembled everything for you.


ARF Package including:

FMX250 250MM mini quadcopter with PCB board and LED x 1
DragonFly MC1806 KV2300 motor x 4
Dragonfly 12a ESC built-in 5V/2A BEC x 4
5030 electric CW/CCW props x 4 pairs
Naze32 Acro Funfly flight controller (ARF 1) / Naze32 full version flight controller (ARF 2) / CC3D flight controller (ARF 3) (optional) x1
SONY Effio-e 4140+811 1/3 CCD 2.6mm Lens 700TVL camera x 1
Hawkeye 5.8g mini 600mw 32CH A/V transmitter x 1
Battery velcro straps x 2
5.8G clover 3-leaf TX antenna x 1
20CM servo extension cable x 2
3M double sided adhesive tape x1
and silicon wires, straps, shrink tubes, T-plug etc that everything showed in the picture.


RTF 1 Package including:

FMX250 250MM mini quadcopter with PCB board and LED x 1
DragonFly MC1806 KV2300 motor x 4
Dragonfly 12a ESC built-in 5V/2A BEC x 4
5030 electric CW/CCW props x 4 pairs
CC3D flight controlle x1
SONY Effio-e 4140+811 1/3 CCD 2.6mm Lens 700TVL camera x 1
Hawkeye 5.8g mini 600mw 32CH A/V transmitter x 1
Battery velcro straps x 2
5.8G clover 3-leaf TX antenna x 1
20CM servo extension cable x 2
3M double sided adhesive tape x1
and silicon wires, straps, shrink tubes, T-plug etc that everything showed in the picture.

Installing instruction: click here
Note: The camera requires 12V power input.
What else you need (choose which you prefer from fpvmodel.com):  Radio, battery(3s 1300-2200mah), receiver and monitor.

[Tecnic]

Nice frame
That's the same as the HK Dart 250 and GLB QAV250 (what I have)

Light weight and plenty tough enough for me, PCB is great, lights are of limited use especially if you want to go 4S cos you'll have to make sure the lights are switched off

I have an APM on mine but have also run a CC3D, loads of room for gear on it, at on etime mine was a fully loaded UAV with telemetry, VTX etc giving full waypoint system, in air programming, Dronie, follow me etc etc

And this is cheaper than HK or GLB