Author Topic: dragonlink link servo test (Read 239 times)

tressner · « **on:** January 20, 2015, 08:09:46 PM »

Just wondering if anyone has an answer or help...my dragonlink seems to be working fine ..but when i put it in servo test mode i lose signal about 50 feet away it almost seems as if its in micro power mode at the same time as the servo test....

bigMouse · « **Reply #1 on:** January 20, 2015, 08:20:19 PM »

Think Dragon link was designed by the same guy as RangeLink, Believe they are very similar setups! The servo test would be in micro mode (1mW from memory), its just to set a reference range the actual distance is not important, 50 ft sounds fine!

tressner · « **Reply #2 on:** January 20, 2015, 08:39:17 PM »

Thanks. I just saw all these videos of people driving down the road well the servos moving back and forth so i thought it was in full power

bigMouse · « **Reply #3 on:** January 20, 2015, 08:44:51 PM »

The idea is to walk away until the servo stops moving, that will be your reference range, had it been on full power you would need to walk to the next county!

That is a of course presuming the servo test is the same on both systems.

Martink1974 · « **Reply #4 on:** January 20, 2015, 09:06:57 PM »

I have dragonlink and ezuhf in test mode 50feet is defo fine when people do a long range test with servos moving they often activate a servo test mode via there tx to cycle servos , I did not no dragonlink was designed by guy that did rangelink ? you sure bm

was it not chainlink he worked on first

bigMouse · « **Reply #5 on:** January 20, 2015, 10:32:18 PM »

I think your right Martin!

tressner · « **Reply #6 on:** January 20, 2015, 10:40:46 PM »

well if the blue lights on that means i still have connection and it stayed on solid well i drove for a 3/4 mile on low ..but that's on a really forested road.. when i got up on a hilly spot or a clearing id get it back ..even a 2 miles out . its not super far but the transmitter was 4 feet up and i was in a car .