Author Topic: Funjet Ultra FAST FPV Build Thread (Read 10843 times)

MrBen · « **Reply #75 on:** December 05, 2014, 06:04:42 AM »

you could easily cruise 15km out at low throttle even with this stupidly powerful setup, you would need some kind of stabilisation to keep the wings level when landing and then point it to a field and hope for the best

MrBen · « **Reply #76 on:** January 11, 2015, 10:30:32 PM »

Funjet electrics are going in a new fuse. This time I am laminating the stabs and the wings.

Stabs done, fuse masked ready for spray glue, Im giving it a coat of 3m90 glue before I laminate

Dusty · « **Reply #77 on:** January 11, 2015, 10:39:24 PM »

would one of those 3 axis gyro stabilisation wotsits do a decent job of compensating for the torque roll?

http://www.hobbyking.co.uk/hobbyking/store/__38543__OrangeRX_RX3S_3_Axis_Flight_Stabilizer_V2_V2_1_firmware_V_tail_Delta_AUX_.html

MrBen · « **Reply #78 on:** January 11, 2015, 11:08:19 PM »

not sure, maybe the control surfaces dont have enough authority at low speeds, anyway torque roll isnt a problem when launching vertical, just let it spin!

MrBen · « **Reply #79 on:** January 13, 2015, 09:08:58 PM »

Ok so now the wings are laminated and the gps, vtx and uhf rx have been carved into place on the underside of the wing. Camera sunk into nose too.

Waiting on some 5 min epoxy now so I can pour a nice coat down the inside of the fuse over the additional spar.