Author Topic: EZOSD RSSI feed problem (Read 1390 times)

Ant · « **on:** October 03, 2012, 09:38:15 PM »

Can any one help with an EZOSD problem ? I have just added the two pins to the current sensor to give an RSSI feed and connected it to my receiver. When i try and calibrate the min and max points the damn thing gives me a min/max value of 137 irrespective of whether the tx is switched on or of ?? The osd screen shows an rssi value of 0 all the time. I even unplugged the rssi lead from rx to current sensor and the rssi value on the osd screen remains.

Have i knackered it ? How do you reset the factory settings ? I tried the immersion tool but couldnt get that to work either!

Help !

mark1975 · « **Reply #1 on:** October 03, 2012, 09:50:49 PM »

Ant what version of firmware are you running on it i ecountered identical problem i updated the firmware through immersion rc and it worked.

Ant · « **Reply #2 on:** October 03, 2012, 10:36:13 PM »

Quote from: Mark Shark on October 03, 2012, 09:50:49 PM

Ant what version of firmware are you running on it i ecountered identical problem i updated the firmware through immersion rc and it worked.

Just upgraded to 1.14 as we speak mate. I have to confess i was taking the +ve and earth from the rx and it should have been earth and signal by the look of it

. Just finished recalibration and it works now in a fashion but rssi goes from 100% to 20 % (not min of 0%??). Guess i will just have to fly until it drops to 50% to be safe !!!

Thanks for the quick reply bud

Ant