kim250 goodluckbuy $40

[xxpitt]

video was nice and sharp been use to my dodgy qav video wiring though lol, prop just look normal to everyone else

[MrBen]

520 grams not bad, an oz lighter than mine should feel a bit lighter in the air then!

[xxpitt]

Still got my neg and pos wires on 3 of my esc's to lose. I just tucked em between the botom platrs but my as well save a gram or 2. I dont have any osd or anything either though so I saved weight there. Though think I might add a simple voltage one later

[xxpitt]

kim250 maiden

lost a prop nut at some point but prop stayed on, didn't fancy risking flying again without on so only got through 2 lipos

[ady.g.]

exciting Dave as always .no boring flights with you. 

[brodjackella]

I go through more prop nuts than props recently

[xxpitt]

Cheers ady  wanted to do more but loss of prop nut ended play. I've lost one every time I've flown it. I'm 2 for 2. 1st time it was a normal nut so just replaced it but now I've lost a left hand one not an easy replacement.  B&Q don't sell em so will be an ebay job. Off tomorrow as well but wont be flying now

[bigMouse]

I think they come off when you hit walls/trees and things, the prop stops suddenly for a brief moment and the nut carries on spinning!
Lost a couple myself... Almost impossible to find in the grass even if you know where it came off!

[ady.g.]

Rcx motors

[xxpitt]

Yeah rcx motors. Never lost a prop nut since ive been flying quads but these minis seemed to be prone to it. Maybe its because of the higher kv motors. But what bigmouse says makes sense.  The motor stops spinning but the nut carries on spining and comes off

[xxpitt]

thought i'd put some pics up of it with the anti vibration plate, works perfect, gets rid of any of the little vibes produced by the tiny motors